This website uses cookies. By using the website, you consent to the use of cookies. Privacy Policy

Consistent quality, hole after hole.
Laser drilling.

Laserbohren von Schrägbohrungen unte 25° zur Oberfläche
  • Drill hole diameters from 30 µm with tolerances of < 10 µm
  • Percussion drilling up to around 350 µm
  • Repetition drilling up to 1,000 drill holes/sec.
  • Aspect ratios of up to 30:1
  • Material thicknesses from 0.005 - 4 mm
  • Max. dimensions of 2,000 x 500 x 300 mm
  • Angled drilling up to 65° to the vertical
  • The smallest heat affected zone

The latest generation of laser sources in combination with high precision motion systems lead to a very high reproducibility and economic production of micro-perforated.

The spectrum of laser drilling reaches from a 30 µm single drilled hole in a metering disc up to several million drilled holes in micro-perforated plates of several square meters.

Laser drilling allows contactless drilling with no force applied to the workpiece. Thanks to very flexible laser sources with a slim design laser drilling with focussed laser beams can be used even in locations with limited access. This allows for the finest drill holes with extreme aspect ratios and low heat effected zone.

Mikroperforiertes Sieb mit 40mm Bohrungen

Constant further development and experience over more than 25 years ensure not only continuous improvement, but also ever more possibilities.

As a result, if you have a task which may not previously have been possible then you’re in the right place with us. We will find a solution for you.

 
 

RJ Lasertechnik GmbH
| Administration: Boschstrasse 20 | 52531 Übach-Palenberg
| Goods Delivery: Fraunhoferstrasse 1
| T +49.24 51.9 10 54-0 | info@rj-lasertechnik.de